The Boot Disk Creator will not recognize the USB memory stick plugged into the system.Can I automatically map a network drive when booting up into Boot Disk for Windows?.Can anyone help me with this and provide some insight as to what I should do next? Mind you, this computer is BRAND NEW.Īttached below are screenshots of the disk appearing while logged into the machine vs while in the Windows PE command prompt. The imaging is a huge part of my job and this has become and crazy inconvenience. You might ask, "If you already have Windows 10 installed, then why do you have to image the machine?" Well by using Windows PE and the Task Sequence Media Wizard, the computer can be automatically added to our organization's Active Directory and all software that is used by the org will automatically be installed and licensed. This is the only machine it has not worked on. The bootable media works on other computers that our organization owns such as Dell Desktops, Lenovo's, and Toshiba's. I have also created multiple USB bootable medias for the imaging to rule out that the bootable media is the issue. I unencrypted the SSD using Windows Powershell and this did nothing either. I have gotten IRST updates directly from the Intel website that Dell might have not published yet and installed them on the machine, as well as loaded onto the boot drive. I updated the machine with all the latest updates provided to me by Dell Support including BIOS updates and Storage Controller updates. I tried loading different Intel Rapid Storage Technology Drivers onto my boot drive and none of them have been successful in getting diskpart to display my SSD. I've played around with all Virtualization settings on the BIOS and that did nothing. This did nothing and did not allow me to boot into Windows 10 at all until I re-enabled RAID. The machine has RAID turned on, so I disabled it and set the SATA/NVMe Operation to AHCI/NVMe mode to see if that would fix anything. I have looked all over a bunch of different forums and I have not been able to get any straight answers. I do not know what the issue could possibly be. The only place it does not appear is within Windows PE on the command prompt. I also went on Disk Management and my SSD appeared. I accessed " diskpart" from the command prompt while logged into the machine and entering the " list disk" command showed me my SSD. Furthermore, the machine already came pre-installed with Windows 10, so I was able to create an account and access the computer normally. If the disk is not formatted, then I cannot image the machine so there lies the main problem. When I do the " list disk" command, only the bootable media inserted into the machine appears (the USB). Before imaging the machine on Windows PE, I typically open up the command prompt and access " diskpart", where I can then format the disk on the machine to my liking so that I can commence the imaging process. We currently use Windows PE for imaging purposes (Task Sequence Wizard). These are the specs: KBG40ZNS512G NVMe KIOXIA 512GB SSD, Intel i7-1185G7, 16GB DDR4 SDRAM 3200MHz, Intel Iris Xe Graphics. Hey everyone, I am in need of some help! My organization just purchased a brand new Dell Latitude 5520 for one of our employees.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |